Design

About design

After receiving the customer's design file (AI/CDR/PDF/ARTWORK format) or typesetting the design for the customer, confirm the production content and production craft.

*Matters needing attention

1.[Lines]

Take note that there may be slight shift of 0.5-1mm during production, whereby any straight lines near the edges of the design may appear slightly slanted.

2.[Borders]

Due to the slight shift of 0.5-1mm during production,

printed borders may appear slightly uneven and will not be perfectly centralized.

3.[Color]

Color difference problem: There will be some deviation between the print and the design file, but it will not deviate from the main color. It will not affect the use. If we take pictures or videos before shipment, if there is no problem. We will not be responsible if you are not satisfied after receiving the goods.

4.[Die cut]

As there is usually a shift in printing/cutting during production, make sure that your design document or supplied picture can be filled to the edge of the discharge size.

*Bleed Size = Trim Size + 3mm Margin Bleed